ABS · DSC · ESP · Replacement control unit
Programming and vehicle integration
Programming, vehicle-specific coding, adaptation and commissioning for supported new or professionally replaced control units – personally handled in Vienna.
Clearly defined scope
This service is for vehicles with a technically compatible ABS, DSC or ESP control unit that has already been installed professionally. Before work begins, we use the vehicle data, part number, diagnostic report and installation status to confirm whether the requested software work is supported.
Software version, vehicle-specific equipment and required basic settings are coordinated for the exact supported system.
Transfer or update the appropriate software version on a supported replacement control unit.
Code the control unit for the vehicle variant and installed equipment.
Perform required assignments, basic settings and learning procedures according to manufacturer specifications.
Check fault memory, communication and the specified final functions after the software work.
Required in advance
Not every part number and software version is compatible with every vehicle. A firm assessment is only possible after checking the complete information.
Send make, model, year, engine and vehicle identification number.
Photograph the original and replacement units with every number and letter suffix visible.
Provide current fault codes and confirm the status of the professional installation.
Confirm support, required steps and appointment before work begins.
Typical situations
Programming and coding may be required after professional replacement when the compatible replacement unit still needs to be matched to the vehicle, equipment or system parameters.
Depending on the system, a technically compatible new part may require software, coding and basic settings.
Feasibility and permissible adaptation depend on manufacturer, part number, software version and unit status.
The vehicle variant and relevant equipment features must match the control unit.
Required learning and commissioning procedures are carried out only for supported systems.
Send vehicle data, part numbers and the diagnostic report to clarify the supported programming service.